putty and caulking way

Preparation:
Putty will harden quickly, about 25 minutes after being mixed with the hardener.
Prepare fiber bodykit parts and fine sandpaper before using putty on it,
 make sure the surface clean of all dust and dirt, use a cleaning cloth.

Process practically putty in the final process of manufacture bodykit before getting into the paint. Caulking process is the hardest and dirtiest processes in all the processes that we have passed, but this process is the process of determining the end result of our work later. Finer detail and semaikin our work is guaranteed in the process of caulking the final outcome of the painting would be perfect

Mixing of putty to hardener:
Mixing putty and hardener are nearly the same as the dose of resin and catalyst mixing, for
more definitely try to read the instructions on the package using putty.
Once mixed, putty will change color, some yellow and green depending on the brand of putty.
Putty that has been blended for use for about 25 minutes, do not mix too much because the putty will get rid of useless.
Use a grading tool for mixing.
Once the mixture is ready, press the putty on the surface of the bodykit, the first thin writing and trying to close
The first uneven. In this section requires experience, try to continue to be. Drain about 1 hour.
A putty form:
Do not do this step before the putty dries, you will start from the beginning that make up the putty dry yet. How to check the putty is dry or not is by way of touching by hand, if it still feels wet and humid conditions means the putty is still not completely dry, dried again under the lights or the sun

Sanding:
Use sandpaper to rough metal surface to form a putty, sandpaper and sandpaper until smooth again, can go to other parts do not forget to use a cloth to clean the surface. If there is a small hole in the surface can be covered with putty on the next process.
Used sandpaper to smooth rough start, it will display fine lines on the surface, this is not a new problem because the first step of sanding. Fine sandpaper is used after the above process, sandpaper until smooth and slippery.
Caulking is actually a job that requires patience, technical caulking is a simple job and not too difficult
good luck