airbrush paint magic

patchwork of damaged paint or paint magic, usually applied to repair collision-damaged paint or paint that is eroded due to friction or old paint.
damage to paint mainly due to the crunch or by accident, the damage is severe enough so that a surface is uneven and must be averaged to recover the form of a surface and then putty to smooth a surface.
if damaged due to minor collisions and only on clear coat. scratch-resistant coating and just need a little polish on the surface will eliminate scratch marks already, but if a collision will damage the color and should be color corrected and then coated with scratch-resistant coating.
is meant to restore the magic paint or re-color spray paint on the surface but no visible difference in the new paint to old paint, at this stage requires a mature technique, starting from mixing colors to color spray paint. , Each color each has its own technique for spliced ​​/ magic paint.
The first thing to note is the fineness of the surface to be painted the color and texture of surface, solid or metallic if metallic whether metallic patterned / rough textured or smooth textured and metallic colors only one color or more than one color, should then be seen under the sunlight or the light will seen clearly how the texture metallic color ..
car body in the present era is more likely to use a metallic color with a metallic texture more than one color
tried to mix the paint results in other media for comparison to the same color, if it is the same then spray on the desired surface does not have to cover the entire surface of the damaged portion only color only and do not forget to pay attention to the basic color of the color before the main color to be equated. because the base color greatly affects the outcome of the color display.
factor of the wind pressure on the compressor must be considered because it influences the results of the spray and spray distance should be considered let alone use a metallic color, do not let the metallic grains too much or too little.
spraying with adequate lighting, done under the sun or a lamp that can clearly see the metallic grains.
if finished then staying and finishing the finishing process of switching to thiner continued if the process of finishing / varnish covering the entire surface.
A good result finishing just need a little polish, polished to remove any dirt or residual dust / spray paint if the perceived bias sweep hand on the surface will feel rough, polished to produce a smooth surface and shiny paint.
good luck